Ideas on Wire & Cable and Pipe & Tube manufacturing. Hosted by Maillefer.
The efficiency of an optical cable manufacturing line can be improved significantly by increasing line speed. But to do so, the manufacturing process itself must be quite robust. It must withstand abnormalities and changes in the factory environment. Maillefer has taken several steps forward in bringing high speed capability to our customers, thanks to nonlinear modeling.
In the loose tube process, excess fiber length (EFL) and post-shrinkage must stay under control during production. The loose tube properties play important role in final cable quality. When EFL is outside tolerances it can cause attenuation increase in temperature cycling. All these properties can be adjusted with correct process parameters. Higher line speeds need tighter tolerances and precisely defined process conditions in order to guarantee good cable quality.
Our secondary coating process is reaching totally new limits for line speeds. With traditional manufacturing speeds increased by 300%, obvious process items must be redefined. First, an accurate model that reflected how the process parameters affect the product quality was developed. Then, it was quite straightforward to optimize the most critical production line parameters and components to reach target line speeds.
The product quality of the buffering process depends on excess fiber length and on shrinkage properties affected by several process variables. Interrelations are complex. Some variables, including line speed, have clearly nonlinear effects on excess length. Linear statistical techniques are not very efficient at describing these interrelations. Developing phenomenological models is often not feasible, and phenomenological models require a lot of assumptions and simplifications, and hence predict process consequences less accurately.
The most suitable approach is nonlinear modelling, which is empirical or semi-empirical and takes nonlinearities into account. It does not require any major assumptions or simplifications, but simply describes the reality as observed. Nonlinear models have been successfully used to improve the productivity of different extrusion processes. It gives deeper insight to production process and allows users to optimize their end product quality and productivity at the same time.
Today’s trend is to produce dry loose tubes without any filling compounds. When bare fibers are placed into tubes at ultra-high speeds, the fiber alignment and line tension control are extremely critical for the process.
With jelly filled tubes, the material properties as well as the jelly filling techniques are the heart of the end product quality. Of course several other variables including crosshead tooling, cooling water temperature, melt temperature, mid capstan location, fiber tension, clinching/compression caterpillar speed and location must be adjusted accordingly to achieve the targeted EFL and post shrinkage properties.
To apply nonlinear modeling, a production plant needs to follow three simple steps.
Production management provides Maillefer with product specifications and normal operating conditions of the process.
Maillefer prepares and carries out a series of trials on the production line over a period of two or three days. We then develop nonlinear models and use them to determine optimal ways of operating the buffering process. Our goal is to reach higher line speeds while ensuring product quality.
A final run is conducted by the production plant to ensure that the optimization efforts work as expected.
Nonlinear modeling has been beneficial for improving our understanding of the optical cable manufacturing process at high speeds. It has led us to innovate on the lines that we deliver today. But that same approach is also available as a service to our customers who seek to improve their line speeds.
Tue November 14 2017